Higher Plants As Bioindicators Of Sulphur Dioxide Emissions In Urban Environments

The evaluation of certain vascular plants that grow in the city of Madrid as biomonitors of SO₂ air pollution in urban environments has been carried out. Total concentration of sulphur in leaves of the chosen higher plants as well as other parameters in close relation to this contaminant (visible injury symptoms, chlorophyll a- and b-content and peroxidase activity) have been determined in order to study the spatial distribution and temporal changes in SO₂ deposition. Results obtained show that coniferous species such as Pinus pinea, were more sensitive to SO₂ atmospheric concentration than leafy species as Quercux ilex subspecies ballota and, in the same way, bush species, such asPyracantha coccinea and Nerium oleander, were more sensitive than wooded species, such as Cedrus deodaraandPinus pinea, respectively. There is a higher accumulation of sulphur in vegetable species located near highways and dense traffic incidence roads and near areas with high density of population. The minimum values for accumulation of SO₂ were registered in winter and spring seasons (from January to April) due to the vegetative stop; while maximum values are obtained during the summer season (from June to September), due to the stoma opening. The highest increments in sulphur concentration, calculated as the difference between two consecutive months, are obtained in May and June for all considered species except forCedrus deodara and Pyracantha coccinea, both species have few seasonal changes during the whole year. Some species are more sensitive to natural washing than others, showing a decrease in sulphur concentration after rainfall periods.     

Using Wet-FGD systems for mercury removal

A plan to control mercury emissions to the atmosphere and to establish mercury emission limits has recently been elaborated by the European Commission, making it necessary to devise an efficient and cost effective mercury removal technology. Towards this end wet flue gas desulfurization units appear as a promising option for multi-pollutant control. However, more investigation on mercury removal and a greater mercury removal efficiency are required to achieve this objective. In the present work scrubber chemistry and the application of various solid additives to enhance mercury removal in wet scrubbers is evaluated. The results obtained show a significant correlation between mercury removal efficiency and the pH of the scrubber slurry and SO2 concentration. A weaker correlation was observed between oxygen or slurry concentration and removal efficiency. Finally several solid oxides were found to be effective additives for enhancing mercury capture in wet scrubbers.     

Degradability and Sediment Sorption of an Alcohol Polyglycol Ether Surfactant Putatively Useful for the Control of Red Swamp Crayfish in Rice Fields

This work reports studies of the degradation rates of a fattyalcohol polyglycol ether non-ionic surfactant, Genapol OXD-080, putatively useful for the control of red swamp crayfish (Procambarus clarkii Girard) in rice fields under laboratory and field conditions. The influence of temperature,sediment site specificity and sorption were taken into account.The degradation kinetics of the surfactant depends on the experimental conditions: type of inocula and temperature. Thedistribution of this chemical in aquatic systems was also examined. Genapol OXD-080 was removed into the sedimentsreadily after application, and sorption was considered the majorpath of removal from the water phase. Data suggest that furtherstudies are required regarding the effects of Genapol OXD-080 in aquatic organisms resident in rice fields, in parallelwith the development of technologies related with the use ofsurfactants to control P. clarkii populations.     

Optimization of a multielement sequential extraction method employing an experimental design approach for metal partitioning in soils and sediments

The optimisation of a simple multielement extraction method employing an experimental design approach is described. The method uses centrifugation to pass one extractant solution at varying pH through a contaminated soil sample. The nature and concentration of the acid, rate of centrifugation and time, number of sequential leachates and the ratio of extractant volume: sample weight have been studied in order to obtain the optimum conditions for extraction. A fractional factorial experimental design was performed, and the results were used to identify significance which was then evaluated by carrying out a central composite experimental approach. Once optimum conditions had been obtained, sequential leaches were analysed by ICP-AES and chemometrics were employed to identify the composition of each component. Comparisons have been made with previous studies and tentative assignments, based on well defined separated fractions and percentage compositions for individual elements, used to identify the different physico-chemical components in the sample.     

Preliminary air pollution monitoring in San Miguel, Buenos Aires

Passive diffusion samplers were employed in San Miguel(Buenos Aires Metropolitan Area) for a preliminary airpollution monitoring. The highest loads were observedin downtown, compared with an urban background site.Total suspended particulate matter (TSPM) varied from0.257 to 0.033 mg cm^-2 month^-1; dust was examinedfor particle nature and size distribution. A similartrend was observed for nitrogen dioxide (NO₂) andTSPM spatial distribution, suggesting that traffic isthe major pollution source. Sulphur dioxide (SO₂)values were low and rather homogeneous. Levels for theinvestigated pollutants are below EPA's guide linevalues. Geographic (flat area, near to Rio de LaPlata) and climatologic factors (rainfalls andvariable wind directions) contribute to disperse pollutants.     

Study of Meteorological Aspects and Urban Concentration of SO2 in Atmospheric Environment of La Plata, Argentina

This article presents and discusses SO₂ (ppbv) concentration measurements combined with meteorological data (mainly wind speed and direction) for a five-year campaign (1996 to 2000), in a site near an oil refinery plant close to the city of La Plata and surroundings (aprox. 740.000 inh.), considered one of the six most affected cities by air pollution in the country. Since there is no monitoring network in the area, the obtained results should be considered as medium term accumulated data that enables to determine trends by analyzing together gas concentrations and meteorological parameters. Preliminary characterization of the behaviour of the predominant winds of the region in relation with potential atmospheric gas pollutants from seasonal wind roses is possible to carry out from the data. These results are complemented with monthly averaged SO₂ measurements. In particular, for year 2000, pollutant roses were determined which enable predictions about contamination emission sources. As a general result we can state that there is a clear increase in annual SO₂ concentration and that the selected site should be considered as a key site for future survey monitoring network deployment. Annual SO₂ average concentration and prevailing seasonal winds determined in this work, together with the potential health impact of SO₂ reveals the need for a comprehensive and systematic study involving particulate matter an other basic pollutant gases.     

Sequential extractions of selenium soils from Stewart Lake: total selenium and speciation measurements with ICP-MS detection

Different techniques have been employed in order to evaluate the most efficient procedure for the extraction of selenium from soil as required for speciation. Selenium contaminated sediments from Stewart Lake Wetland, California were used. A strong acid mineralization of the samples gives quantitative total selenium, which is then used to estimate recoveries for the milder extraction methods. The different extraction methodologies involve the sequential use of water, buffer (phosphate, pH 7) and either acid solution (e.g. HNO3 or HCl) or basic solutions (e.g. ammonium acetate, NaOH or TMAH). Pyrophosphate extraction was also evaluated and showed that selenium was not associated with humic acids. The extractants were subsequently analyzed by size exclusion chromatography (SEC) with UV (254 and 400 nm) and on-line ICP-MS detection; anion exchange chromatography, and ion-pair reversed phase chromatography with ICP-MS detection. For sequential extractions the extraction efficiencies showed that the basic extractions were more efficient than the acidic. The difference between the acidic and the basic extraction efficiency is carried to the sulfite extraction, suggesting that whatever is not extracted by the acid is subsequently extracted by the sulfite. The species identified with the different chromatographies were selenate, selenite, elemental selenium and some organic selenium.     

A study of the distribution of lead, cadmium and copper between water and kaolin, bentonite and a river sediment

Experiments were carried out to monitor the equilibrium distribution of lead, cadmium and copper between an aqueous phase modelling natural water and a solid phase modelling natural sediment, under varying conditions. The aqueous phase was analysed using ETAAS and differential pulse anodic stripping voltammetry (DPASV), whereas XRD and FTIR were used to study the solid phase. Sorption isotherms at constant pH were measured. Conditional distribution constants were calculated as functions of the pH, the time of equilibration and the amount of solid material. The results obtained stress the need for standardization of the approaches to the study of water-sediment interactions in order to be able to evaluate and compare the extensive data from field measurements and to predict these interactions.     

Improvement of the BCR three step sequential extraction procedure prior to the certification of new sediment and soil reference materials

The Standards, Measurements and Testing Programme (formerly BCR) of the European Commission proposed a three-step sequential extraction procedure for sediment analysis, following extensive expert consultations and two interlaboratory studies. This scheme was recently used to certify the extractable trace element contents of a sediment reference material (CRM 601). Although this procedure offers a means to ensure the comparability of data in this field, some difficulties concerning the interlaboratory reproducibility still remain, and a new project is currently being conducted to determine the causes of poor reproducibility in the extraction scheme. The final objective of the project is the certification of new sediment and soil reference materials for their extractable contents of Cd, Cr, Cu, Ni, Pb and Zn. This paper presents the results of a small-scale interlaboratory study, which aimed to test a revised version of the extraction schemes by comparing the original and the modified protocols using the CRM 601 sample. This work offers an improvement to the BCR sequential extraction procedure through intercomparison exercises. This improved procedure will allow the obtaining of CRMs to validate analytical data in the analysis of soils and sediments, and it will also facilitate comparability of data in the European Union.     

Atrazine and Alachlor Inputs to Surface and Ground Waters in Irrigated Corn Cultivation Areas of Castilla-Leon Region, Spain

The inputs of atrazine and alachlor herbicides to surface and ground waters from irrigated areas dedicated to corn cultivation in the Castilla-León (C-L) region (Spain) as related to the application of both herbicides were studied. Enzyme-linked immunosorbent assays (ELISA) were used for monitoring the atrazine and alachlor concentrations in 98 water samples taken from these areas. Seventy-nine of the samples were of ground waters and 19 were of surface waters. The concentration ranges of the herbicides detected in the study period (October 1997–October 1998) were 0.04–25.3 g L^–1 in the surface waters and 0.04–3.45 g L^–1 in the ground waters for atrazine, and 0.06–31.9 g L^–1 in the surface waters and 0.05–4.85 g L^–1 in the ground waters in the case of alachlor. The highly significant correlation observed between the concentrations of both herbicides in the surface waters (r = 0.89, p < 0.001) pointed to a parallel transport of atrazine and alachlor to these waters. A study was made of the temporal evolution of the concentrations of both herbicides, and it was found a maximum recharge of atrazine in the ground waters for April 1998 and of alachlor in October 1997 and October 1998. The temporal evolution of the concentrations of both herbicides in surface waters was parallel. The highly significant correlations observed between atrazine concentrations determined by ELISA and by HPLC (r = 0.92, p < 0.001) and between alachlor concentrations also determined by both methods (r = 0.96, p < 0.001) confirmed the usefulness of ELISA for monitoring both herbicides in an elevated number of samples. Using HPLC, the presence in some waters of the alachlor ethanesulfonate (ESA) metabolite was found at a concentration range of 0.52–4.01 g L^–1. However the interference of ESA in the determination of alachlor by ELISA was negligible. The inputs of atrazine and alachlor to waters found in this study, especially the inputs to ground waters, could pose a risk for human health considering that some waters, though sporadically, are even used for human consumption.